"Sorry i haven't seen this earlier. There's no particular reason other than convenience or actually finding a place to put it. But I've just started another build and mounting this one right side up. When working with limited mounting area it's nice…"

"Got mine here http://www.ebay.com/ulk/itm/201480328841

A bit cheaper and it shipped out immediately."

"The only thing that the Picfalcon is missing is the dual GPS inputs and also RC outs, which you would use for something like gimbal control or landing gear through the FC. You can still use a gimble or landing gear. I'm not sure if the Xracer has…"

"Depends on the crash. I've had a few minor ones. It held up okay. I had the plastic 3DR mast before and that didn't last long, hit branch, damn trees"

"Does the XRacer have a dampened internal imu? Also, what about barometer or barometric sensors? There's no case on this, I would think the prop wash would be a slight issue. I tried the HK pilot 2.7.2 which worked but i had issues with the barometer…"

"Here's the type of frame I used http://www.ebay.com/ulk/itm/191662522359 and here is the type of mast I used http://www.ebay.com/ulk/itm/111589493470 please don't purchase from this place. They have sold me bad parts before and wanted me to more…"

"Don't buy the Pixfalcons from bangood, there's a post about it somewhere. I posted a link of the one I bought. The quality is excellent, I'd say it's as good as the 3DR quality. But again, watch out for bangood and a few other Chinese knockoffs."

"Being a APM and then Pixhawk fan, I like the Pixfalcon. It pretty much has everything you need for a race spec quad and is only slightly bigger than a cc3d. I've alway had good luck mounting my autopilots upside down and then changing the settings…"

"So? Has anyone accomplished this build yet? Seems strange that dys would mass produce this without a solution for the best mass produced FC."

"Did you ever get any help with this issue? If you did please post your results. It's hard to believe you didn't get any response here. I haven't had this exact issue before but I had experienced the "toilet bowl effect" on my first build. I got away…"

"It would be nice to see this on apm and pixhawk."

"But a reset PID button would be really nice! It would be a very useful addition to MP"

"If you go in to terminal tab, connect. Then setup enter and reset enter or test enter reset. You can also try it by replacing reset with erase. Keep in mind this will erase everything. You will have to completely set up your apm like it was the…"

"This is the default pid settings. It would be nice if the was a calculator of some sort.image.jpg"

"I've done that myself a few times"