Discussions

Posted by Peter Koch on January 8, 2011 at 1:01am

Hi,

just would like to know if there is a way to connect the new Futaba S.BUS receiver via serial bus to the APM?

regards,

Peter

You need to be a member of diydrones to add comments!

Email me when people reply –

Jake Stew June 5, 2012 at 11:10pm

The APM apparently uses an analog system (PPM) for interfacing with receivers and communicating from the input processor to the main processor. So it will be no small task to switch to a digital system.
LAIC May 7, 2012 at 1:50am

hello there

- any news about s-Bus and AMP2 ?

regards
Ramanf May 7, 2011 at 10:35am

I would like to know that also, i realy need my APM to work with Futaba S.BUS receiver .

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.