Discussions

help... arducopter 2. fly in auto-trim mode

Posted by mc_don on June 24, 2011 at 5:01am
i try to set level on fly in auto-trim mode
and after trim my qc is very level..
but when i connect board to APM software.. and put my qc on the table

the accl sensor on APM is not on  level position

this my print screen

3690874548?profile=original

 

 

 

 

 

 

 

 

so when i go to alt hold mode the QC is hard drift

and the loiter mode is not lock in position. same hard drift to :(

i have set loiter radius to zero. and not change any PID setting.

 

same one can help me?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • mc_don June 25, 2011 at 11:27am

    now I understand about setting auto level
    thanks a lot

    My next home work now is to try to hold potision

  • Russell B. Sutton June 24, 2011 at 12:43pm
    I have had all these problems,  after leveling and auto trim, my quad is very stable, but the artifical horizion is off a few deg.
  • mc_don June 24, 2011 at 10:51am
    waiting the master respon  :)
  • Wayne Harton June 24, 2011 at 8:25am
    I have the same problem approx 7 degrees out and high. looks horrible but flies good even in alt hold. Is there anywhere in the GCS code where we can change the angles so that the artificial horizon is level or is it a set up problem with the quad? I have been messing with this quad for about six months and never seen this behavior but I have just replaced a motor & props after a crash (I switched from stable to auto by accident and before I realized what was happening the quad came straight at me and crashed on the patio.It could have damaged the board. Any help/suggestions would be appreciated
This reply was deleted.

Activity

Jose Araujo liked Jose Araujo's profile
Aug 29
spencer harvey liked spencer harvey's profile
Jul 9
More…