hi,
since i tried to plug my android phone using OTG and droidplaner, my arducopter is a nightmare, can t arm it anymore, sometimes no led sequence (a,b,c) weird beep , radio is fine calibrated) i ve recorded a video for you, if you have any clues, please share, i would like to fly!
Replies
I recomend the telemetry modules from 3DRobotics, take a look here:
https://github.com/arthurbenemann/droidplanner/wiki/How-to-connect
today i wanted to fly, i power it once, a b c led were solid state, unplugged the lipo, replugged, anda b c never lighted again :/ i am coarsed...
You receive the message probably because you don't have any app that recognizes that device, but I'm just guessing.
Anyway, if you get a telemetry module it'll work.
if you rush... you mess up :) and yes, sometimes calibration just f***s up.. with no reason.. :)
Happy it runs.. have fun flying! :)
Calibare each ESC on its own with the receiver you have in there.. just take the throttle out, which goes to the APM and plug the ESC directly in... power all down, put the throttle on MAX, power all up, Transmitter first. Wait for right soundsequence, move your throttle stick to zero and power down the receiver... thats one.. repeat with the other 3 esc. If your ESC needs diffrent calibation settings.. most should work this way... you have to quickly find out.
Just watched the video... and have to ask.. beeps come from the ESCs right, the beep beep beep endless is a ESC telling that his calibration is messed up.
if it still doesnt work.. it must be a setup mistake on the stuff you added :) always reverse enginer first..
if you install 2.9 again... does it work as usual?
Does it work if you flush back?