Hi everyone I'm having a problem with setting up power mangement with ArdupilotOne (ardurover):



I was looking at the ardupilot mega wiki on how to configure the voltage sensor for high voltage setups:



and they said to change some configuration settings (voltage divider ratio etc) in the source files. I can find these settings in ardupilot mega source so that I can change it but not in the ardupilotone source (ardurover) which is what i'm using. Is battery monitoring not supported in ardupilotone or am I not looking hard enough because I looked through the source and just cant find it.


Is there anyway I can setup power management (battery monitoring) with ardupilotone?







You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –


  • Isn't it just soldering a new resistor in?  If I understand it properly (and I probably don't :-P ) your voltage divider should always output 5V if the batteries are charged.  If not, the divider outputs less than 5V and if it crosses a threshold you declare the battery dead.  Why change the settings?


This reply was deleted.


David Hori liked Isabella Domi's profile
Jan 12
gotham liked gotham's profile
Dec 3, 2020