Arming problem after recalibration with MissionPlanner
After using MissionPlanner to recalibrate my quadrocopter I have struck a problem. The indicator light on the board locks to armed status as usual but the motors will NOT start. I can also disarm this function with TX sticks. I have run all motors independently and have also reset the throttle range at the same time. The motors will not start so what have I unknowingly switched off when running MissionPlanner? I am not an electronics expert or for that matter a computer nerd, but I would still like some help.
Thanks in advance
You need to be a member of diydrones to add comments!
Replies
Does Mission Planner HUD read 'ARMED'? If so and the motors aren't armed, I would try ERASE, RESET, set up again.
Also, when posting for help its a good idea to list your AC version, MP version, details of your vehicle. If the motors/ESCs are the problem then give details.