Gender
Male
About
Location
Qld
Please tell us a bit about your UAV interest
getting one to fly correctly
Hometown:
GRANTHAM
Activity Feed
"I am sure most will say not again, Pixhawk telemetry. I do need help and all can be reassured that I have spent many hours scouring the net for useful information. I am not new at quadcopter flying, I started in 2012 and have progressed through many…"
"I have had similar problems and expect more as I learn. I have found that once I calibrate the TX in Mission Planner I then have to calibrate the ESC's. I do this one at a time. The most recent issue was the light in the board locked to ON but the…"
Arming problem after recalibration with MissionPlannerAfter using MissionPlanner to recalibrate my quadrocopter I have struck a problem. The indicator light on the board locks to armed status as usual but the motors will NOT start. I can also disarm…
"I don't know where you live but this bloke is worth a try.
Robert PhippenWolf Modelswww.wolfmodels.netPh 07 54657897QueenslandAustralia"
Robert PhippenWolf Modelswww.wolfmodels.netPh 07 54657897QueenslandAustralia"
"You have received some real sound advice, go simple for starters. I have been flying models for the best part of the last 50 years and only started to experiment with quads about 18 months ago. I found the KK2 flight control board to be easy to use…"
"Thank you, about bloody time. I have put dust covers over my Ardu and am using my KK2 instead. The uploading of information from computer to the flight controller is too complex, not all of us out here are computer nerds. I got 32 flights from the…"
"I have experienced arming problems with 3.0.1 and found I had to set my throttle trim to the lowest value possible, just a thought"
When I load Mission Planner 1.2.5 mav 1.0 The right hand side of the screen shows the following error message "Exception:The remote server returned an error: (404) Not Found." How can I fix the problem?
How can one get some help?I am quite familiar with Quadrocopters as I have mastered flying with a KK2 board and decided to move up to the next level in the case the Ardu flight controller. Constructed a new frame etc, and then successfully flew the…
