I successfully installed the firmware onto Pixhawk with APM2.
But the wizard menu did not show to allow me to do the wizards to set up the Pixhawk.
I downloaded and installed Mission Planner and I was able to confirm the firmware was installed and was able to select the setup wizard.
However, it fails while trying to connect with Mavlink with timeout and "No Heartbeat Packet Received" error.
I have 3 USB ports on my ASUS X53E laptop and tried all of them with the same results. Running Windows 7 Home Premium Service Pack 1.
The Pixhawk shows normal led indication, the GPS also show normal led indications, the RX (R7008SB) is showing power with red LED and the safety switch is flashing quickly.
On power up with usb connection the Pixhawk does the correct tune followed by two beeps to indicate ready and running...
SO what now I am stuck? Please help.