Hi everyone, I searched this problem and there were a few hits. I've successfully calibrated the acceleration and compass but get blank bars when doing the Radio Calibration. The radio is bound to the RX and all servos work. I got HUD and GPS lock but can't proceed with initial setup without the radio calibration.
I'm using Pixhawk PX4
MP 1.3.34
Arduplane 3.4.0
Taranis + 9XD (XJT module not yet installed)
X8R Reciever
Zeta Science FX79 Buffalo Flying Wing
One person who solved their problem reversed throttle on the radio. Not sure how to do this on the Taranis.
Replies
I don't think that you are powering the receiver.
You need to power up the servo rail, connect your esc to main out 3, this will power the rail and the receiver.
Also you should connect all three wires of your wing servos to Main out 1 and 2, not just the signal wire and not to Aux out 1 and 2 as Craig's diagram shows.
I've made a bit of a video of where I'm at now with the servo setup doing wierd things.
-
1
-
2
of 2 Next