You need to be a member of diydrones to add comments!
This reply was deleted.
RT @chr1sa: Donkeycar 4.4 released with tons of new features, including path learning (useful with GPS outdoors), better Web and Lidar supp…
RT @NXP: We are already biting our nails in anticipation of the #NXPCupEMEA challenge! 😉 Did you know there are great cash prizes to be won…
RT @gclue_akira: レースまであと3日。今回のコースは激ムズかも。あと一歩 #jetracer https://t.co/GKcEjImQ3t
UC Berkeley's DIY robocar program https://roar.berkeley.edu/
RT @chr1sa: The next @DIYRobocars autonomous car race at @circuitlaunch will be on Sat, Dec 10. Thrills, spills and a Brazilian BBQ. Fun…
RT @arthiak_tc: Donkey car platform ... Still training uses behavioral cloning #TCXpo #diyrobocar @OttawaAVGroup https://t.co/PHBYwlFlnE
RT @emurmur77: Points for style. @donkeycar racing in @diyrobocars at @UCSDJacobs thanks @chr1sa for taking the video. https://t.co/Y2hMyj1…
RT @SmallpixelCar: Going to @diyrobocars race at @UCSDJacobs https://t.co/Rrf9vDJ8TJ
RT @SmallpixelCar: Race @diyrobocars at @UCSDJacobs thanks @chr1sa for taking the video. https://t.co/kK686Hb9Ej
RT @PiWarsRobotics: Presenting: the Hacky Racers Robotic Racing Series in collaboration with #PiWars. Find out more and register your inter…
RT @Hacky_Racers: There will be three classes at this event: A4, A2, and Hacky Racer! A4 and A2 are based around UK paper sizing and existi…
RT @NeaveEng: Calling all UK based folks interested in @diyrobocars, @f1tenth, @donkey_car, and similar robot racing competitions! @hacky_r…
Can you guys help me, What ist the hobby king s550, I read it few times in the discussions here, was wondering about it.
I recently assembled a S500 quad with Pixhawk, and Emax 30A BLHeli firmware ESC. It took me a while to have all the 4 ESC calibrated using "All At Once " calibration. But when reducing the throttle to minimum, the motors on the right hand side (motor No. 1 and 4) stop first before the other 2 motors. Log Analysis on Mission Planner has following warning :--
Test : Motor balance = WARN -- Motor Channel averages = (1559, 1497, 1431, 1415)
Average motor output = 1475
Difference between min and max motor average =144
Not sure if it is due to my messing up with the programmable parameters during calibration, causing one ESC has some parameters different from the other (I also tried one by one calibration ). I don't have a Emax programming card and it is very difficult to enter program mode using transmitter.
What firmware did your ESC flash with, SimonK or BLHeli ? If BL Heli, what are the problems ?
Following is the link to the data flash log :-
Gerardo Espino said:
Has the issue Pixhawk faces with EMAX ESCs been resolved?
Thanks. Any suggestions on a good ESC 30A that works with Pixhawk 4?
The 30a emax esc is a bag of problems. Maybe you wwill need another setup.