Discussions

Posted by Siddharth Shivalkar on August 29, 2020 at 8:44am

hi friends,

I have a strange issue with the Pixhawk 2.4.8

the Pixhawk board gets detected by the Win7 system and also by the Mission Planner when connected via the USB port.

but whenever I plug anything into the I2C port ( GPS / I2C Extender etc.) the Win7 machine gives error connecting to the Pixhawk board.

the USB gives a “Unknown Device” error and the Pixhawk board fails to get detected by the system.

what is causing this?

You need to be a member of diydrones to add comments!

pixhawk, i2c, usb error

Email me when people reply –

Eagle Wong September 2, 2020 at 4:33pm

There is no enough power from usb to give addition power to i2c device, i2c device should have separate power source.

This reply was deleted.

Chris Anderson liked Zara Mae Pickering's profile

Azjeg liked Azjeg's profile

Benewake LiDAR liked Benewake LiDAR's profile

Gremsy liked Gremsy's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.