Pixhawk not being recognised by windows 10

Posted by Christopher Lee on December 17, 2018 at 12:48pm

Hello everyone. I hope all is doing well.

I have a pixhawk flight controller for my f450 frame. I have got it all put together and wierd up. I have installed mission planner and I believe the USB drivers were downloaded with the mission planner. When I plug the USB cord into my computer, windows tells me that the USB device is not recognized and in my task manager, it states that the device malfunctioned and is not recognized.
Has anyone had a similar issue?
How can I go about fixing this issue?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Christopher Lee December 18, 2018 at 8:24am

I went ahead and downloaded the driver and unzipped it and ran the installers. unfortunately, I am still getting the same error. Is there anything else I can do?

Thanks,

Greg Covey said:

Download the driver below and you should be all set.

CP210x USB to UART Bridge VCP Drivers

Pixhawk not being recognised by windows 10

Hello everyone. I hope all is doing well.I have a pixhawk flight controller for my f450 frame. I have got it all put together and wierd up. I have in…
Greg Covey December 18, 2018 at 8:04am

Download the driver below and you should be all set.

CP210x USB to UART Bridge VCP Drivers

USB to UART Bridge VCP Drivers - Silicon Labs

The CP210x USB to UART Bridge Virtual COM Port (VCP) drivers are required for device operation as a Virtual COM Port to facilitate host communication…

This reply was deleted.

Discussions

Pixhawk not being recognised by windows 10

Replies

Activity