Hello all, why is that? i just wanted to hover to test vibrations from my new camera setup, but when decided to land, the quad mantained the motor spinning despite my 0 throtle input... then flipped and ruined two bearings in 2 of my motors :(( when it finally stopeed....
Only mode used was stabilize, APM2, 2.7 firm, quad X, radio well configured , flied all modes ok...
some other strange behaviour is need to re arm everytime I land or touch ground...but i thing this one is normal.
thanks for any clue
Replies
You may not have your radio calibrated properly. please redo the calibration.
Jason
This happens if you have enabled the ALT_HOLD mode and try to land with it while it is engaged.
The solution is to land in STABILIZE, not in ALT_HOLD.