Discussions

Sik 2.x in 3DR radio

Posted by Jesus on December 28, 2015 at 3:20am

Dear all,

  Anybody tried the sik 2.x in 3dr radios in order to use in multipoint configuration? I´ve read this topic:

http://diydrones.com/forum/topics/3dr-915-multipoint-with-sik-2-x

  

  But I think that the firmware posted is for the RFD900, so I´m not sure if it will work, anybody has the firmware compiled por the hm-trp radios?

  

  Thanks

  Jesús

  

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Carsten Groen December 30, 2015 at 5:40am

    I have tried this with success (non flight, just in lab) on 2 x 3DR radios and a HM-TRP module on my own hardware.

    Used this firmware (MPSiK 2.5)

    Follow the description about setup etc from the RFD users guide (Node numbers etc)

    MPSiK V2.5 radio~hm_trp.ihx

    https://storage.ning.com/topology/rest/1.0/file/get/3702152726?profile=original
    • Jim Gordon > Carsten Groen February 15, 2021 at 7:27am
      Thank you so much!!! I searched for over four hours for a MPSIK update that worked with my generic 3DR.

      I am using it on GPS equipment to send RTCM to my rovers. I have two rovers and needed MP.

      I use a RFD900+ on my base, which the software from the RFD site worked fine on it. My Chinese made 3DR was the issue.

      FYI, I mainly joined this forum just to tell you thank you.
      • Jim Gordon > Jim Gordon February 15, 2021 at 9:11am
        Only downfall I have noticed is you must use RFD tools to config but when doing multiple, you need to use AT commands. Otherwise it works great with RFD's 2.5 or 2.6
    • Jesus > Carsten Groen December 30, 2015 at 6:22am

      Thanks a lot!!!

        I´m going to test it! :-) 

        Cheers

        Jesús

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…