Discussions

Two frames, one APM

Posted by Ty on June 13, 2013 at 12:59pm

Hi. I currently have a quad arducopter. I am also building up a hex. The plan was to be able to just take the electronics stack from the quad and put it on the hex when I wanted to fly it. I figured all I would have to do is plug everything back in and change the firmware type, depending on which frame I was flying.

Is it this simple or are there complications I'm not realizing with this?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • T3
    Richard Boyhan June 13, 2013 at 5:58pm
    It's a bit of pain switching back and forth. But you're right if all you are doing is moving either just the APM or Reciver or both it just that simple.
  • cirilo June 13, 2013 at 1:11pm

    This is just as simple. Just make sure you connect the motors correctly to the APM, upload the right firmware and you should be good to go !

This reply was deleted.

Activity