Discussions

Where's the FW Update Tab in 1.2.65

Posted by Steven G on August 3, 2013 at 5:42am

I have searched all over but for the life of me, I cannot find the firmware update page. You know, the one with all the vehicle sketches. Am I blind? Please help if it's obvious and I just missed it. :0

Thanks,

Steven

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Developer
    Michael Oborne August 3, 2013 at 7:48pm

    the reason behind this change is a lot of people where complaining about accidently clicking the tab, and then having to wait because they didn't have internet connection. this was done to resolve that.

  • Developer
    Michael Oborne August 3, 2013 at 5:15pm

    disconnect. and it will apear

  • Moderator
    Nathaniel Caner August 3, 2013 at 4:45pm

    Is it missing for you in 1.2.64 or just 1.2.65? If you went straight from 1.2.63 to 1.2.65, did you try going to 1.2.64 then from 1.2.64 to 1.2.65? It works fine for me, and from what I can tell the only difference is that I applied the 1.2.64 update before I moved to 1.2.65.

    Regards,

    Nathaniel ~KD2DEY

  • Steven G August 3, 2013 at 1:29pm

    I am aware that FW Install should be in the Initial Setup tab in 1.2.64 and up. However, for me, it's not. When I revert back to 1.2.63, its there again under the Hardware tab.

    Steven

  • Brian S August 3, 2013 at 12:01pm

    Initial Setup tab/Install firmware. Hope this is what your looking for.

This reply was deleted.

Activity