I just addes a 5v ubec to my system for powering the APM it solves a lot of sonar issues for me. But I just measured and the ubec gives 5,3v instead of 5v is this a problem for the apm or is it ok?
You need to be a member of diydrones to add comments!
Replies
Ok just to be clear i connect the ubec through an empty servo port on the apm. Not soldered to the apm itself. It is ok?
i think it shouldnt be any problem on that. The reading from my ubec is 5.3v too. But for xtra safety get a small on/off switch
in between ubec and the apm. My previous apm got burn even with the ubec. The spark from d Lipo batt burned the board