Discussions

Xbees settings

Posted by Bastien Carrillo on November 12, 2010 at 2:54am

Hi all,

I'm trying to configure Xbees for telemetry and I'm facing a lil' problem:

Each Xbee has been set up with X-CTU and have same channel, ID and 115200 Baud rate.
When I start a Range test, the Tx LED's of both PC side and Ardu side are blinking, so it seems that there is communication between them.
Rx LED's don't blink and X-CTU says "Timeout waiting for data"
From time to time, Rx LED's blink a little, but never more than 1 second. During the last test, the "Good results" was only 1% on 300 tries...

Has anyone an idea to solve it?

Thanks!

You need to be a member of diydrones to add comments!

Email me when people reply –

Replies

Ahmed Rehan December 2, 2011 at 12:15pm

you have to connect at 57k baud for ardu and PC then check
Peter Seddon November 12, 2010 at 6:44am

This may help: http://www.diydrones.com/profiles/blog/show?id=705844:BlogPost:1990...

There is also some discussion about such issues in this thread http://www.diydrones.com/profiles/blog/show?id=705844:BlogPost:1635... - you may have to go back a couple of pages to pick up the start.

Peter

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.