About

Gender

Male


Location

lahore


About Me:

Electronics and UAV intigrator.


Please tell us a bit about your UAV interest

www.techno-crafts.com


Hometown:

Lahore


Activity Feed

Ahmed Rehan posted a discussion
I wonder if anyone tested dji ocusync air and racing goggles with pixhawk mavlink data and hd video.It has input for futaba tx and sbus output also mavlink support with hd video and 7km range.
Nov 19, 2018
Ahmed Rehan replied to Arif Saleem's discussion Help!! uBEC wire almost burnt powering APM2.5 on Skywalker Maiden in ArduPlane User Group
"It seems you are getting power +ve from main wire of battery and ground from balance connector other wise both wires should melt check your main connection to speed controller it is not connecting main ground wire it is taking ground from your…"
Nov 14, 2014
Ahmed Rehan replied to Cala's discussion Catapult for a Skywalker plane in Catapult & Bungee Launchers
"You need some mechanism to stop the shuttle otherwise it will hit at the end better to take pulley in center and use your bunjee to take the shock."
Nov 6, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Hi Tridgell / Gary

If motor stops and plane is in auto mode loitering over head will it decent in glide mode or try to give elevator to maintain altitude . As in my last flight it nose dived after motor stops on low voltage."
Nov 5, 2014
Ahmed Rehan replied to Michael Levesque's discussion Possible Composite X8 in X8
"I have done a 2M wing with composite and non composite versions will start producing them shortly."
Oct 30, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Jeff what is your RTL altitude?"
Oct 16, 2014
Ahmed Rehan replied to Chris Stacey's discussion Skylark AAT Antenna tracker with APM 2.0, APM 2.5 and u-blox LEA-6H GPS??
"I am also working on interfacing with Skylark ata . there are two options first to get signal through audio channel of video TX and second to get output from Mission Planner in second case have to make some sort of interface. i dont know what…"
Oct 16, 2014
Ahmed Rehan commented on Ahmed Rehan's blog post Three Part 2M Flying Wing
"about 20min on 5400mah 4s 14.8v pack with 3 x packs aiming for 60min."
Oct 15, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Today Auto takeoff worked perfect will try auto landing in next flight any suggestions on approach of autolanding height and distances."
Oct 15, 2014
Ahmed Rehan commented on Ahmed Rehan's blog post Three Part 2M Flying Wing
"Wing span is 2 meters airfoil is bit custom of mh series"
Oct 14, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Thanks to every body specially Tridge / Gary
Just Tested with new calibration worked perfect tuned with auto tune.  tested FBW_A and auto mode also worked perfect. The P gains were too low as default . will test auto takeoff and land and will…"
Oct 14, 2014
Ahmed Rehan commented on Ahmed Rehan's blog post Three Part 2M Flying Wing
"Yes We will produce them shortly any suggestion are welcome.  They are made from EPS covered XPS sheet then covered with Plastic film ribs and center structure are cnc cut plywood with carbon fiber spar.It can be fitted with front or rear motor What…"
Oct 13, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Hi Tridge
attach pl find the log of successful flight.
Ahmed2014-10-02 13-36-48.tlog"
Oct 13, 2014
Ahmed Rehan commented on Ahmed Rehan's blog post Three Part 2M Flying Wing
"thanks"
Oct 13, 2014
Ahmed Rehan posted a blog post
Two wings are ready for flying with APM 2.5. Below, some more pictures with different views:Three Part 2M Flying Wing easy to assemble fins are also removable:Top View with folding propeller and motor installed  Bottom View Bottom pod is…
Oct 13, 2014
Ahmed Rehan replied to Ahmed Rehan's discussion ArduPlane 3.1.1 not working proper on flying wing
"Gary /  Tridge one thing i cant understand it flew one mission with the same setting ok navigating all waypoints and then started orbiting over head. "
Oct 13, 2014
More…