AttoPilot 90A/50V Voltage/Current Sensor

Posted by Joe on August 17, 2011 at 7:12am

Hello,

 

Has anybody had any success with the  AttoPilot 90A/50V Voltage/Current Sensor as described in the instruction wiki?

I am able to get the voltage portion portion working via AN0 but have kinda ran into a brick wall regarding the current sensing input to AN1.

 

Any thoughts would be appreciated!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Daniel Portillo November 9, 2011 at 10:24am

    I've had the same problem,I did the same steps like your, and I have not yet found the solution.
    The voltage sensor indicates relatively well, but has a deviation of approximately 0.4V.

  • Developer
    Doug Weibel August 17, 2011 at 11:02am
    I have it working well.

    You didn't really give any info as to what sort of problem you are having, so it is difficult to make any suggestions. What is happening?
This reply was deleted.