Hi there!

I am very new to this forum and I would like to try to get started by building an ArduPlane.

I can fly an airplane model, I have some manual and electronic engineering skill, and I am pretty good when it comes to software.

Unfortunately, when it comes to aerodynamics, I only have experience by building heavy wood and combustion engine aircraft models.

I am looking for advice on a pre-built model "case", ready to assemble: something cheap to start with but spacious enough to fit all the basic electronics (radio, gps, servos, battery, a camera, fpv system and, of course the control board and the required sensors).

Thank you!