Replies

  • Developer
    Philip April 6, 2014 at 2:09pm
    I suspect you will need a new receiver, this is a 4 chan, not 6.
  • Developer
    Philip April 5, 2014 at 3:26pm
    On the picture you sent, there are normal three pin connectors for ch 5+6 can you take a photo of the actual receiver?
  • Developer
    Philip April 5, 2014 at 12:18pm
    Looks like they are standard servo connections
    So you can use a normal female to female and connect chan 5 or 6 to ch 8

    That will give you only 2 modes, but that's ok
  • Developer
    Philip April 4, 2014 at 8:14am
    Can you post a picture of your receiver? Which pins are the two wire canes attached to?

    If they are outputting ppm, then it will be simple to set up.
This reply was deleted.