Ublox 3DR
No more GPS fix, bad GPS health on MP, compass working OK.
Power on Ublox says 4,87v when connected to USB and 4,95v when connected to Lipo
I have the jumper off and a 5V bec on the outputs, everything worked fine until now.
I suspect some cable / connection issue.
What is the exact voltage mean to go to the GPS please ?
Thank you
Replies
Well I am underpowered, not overpowered
Here is a chart. It looks like I am losing all sats, then it comes back. Cable issue ?
Can you add the HW Voltage to that chart?
I had the same issue, it turned out that my BEC supplying 5.5v was actually supplying 6v..
In your APM Planner, there is a parameter that shows you the HW voltage, it should be less than 5.4v. If it's more, I think there is just a resistor so the voltage goes up to the GPS..