Arducopter 2.6 willl not recognize RC

Posted by Jason W on June 25, 2015 at 10:52am

Hello all,

I am experiencing an issue with apm 2.6 not recognizing my RC.

when in Mission Planner I dont show any stick movements at all.

I am using a Flysky TH9X Transmitter with a FS-R9B Receiver.

On my initial setup running the wizard I was able to configure radio but

after I went back to do another calibration to setup my flight modes I have

not been able to even get APM to even recognize the controller.

Any help would be greatly appreciated as I have been at this for awhile now with

no luck.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • David Pulvermacher June 26, 2015 at 1:03am

    Are you sure your receiver is still bound to the Tx?

  • Mike Boland June 25, 2015 at 1:00pm

    Had similar issues.

    I was able to resolve the communications issues by un-installing/re-installing the correct drivers for the USB ports.

This reply was deleted.