Battery power module 6s?

Posted by cleninton on February 24, 2016 at 8:43pm

Hi I'm new here
  I'm building a octocóptero I need this lift enough weight then I'm getting engines running at 6s 22.2 v battery with drive 2800 grams per axis, but I encounter a problem, the power module only supports 4s Battery 14.8 v with this the push each moto drastically low.
You could put no power module but not know if I'm about to run out of battery and you could end up in a terrible accident.
because of that the power module is imperative.
Can anyone give me an idea of what to do in this case?
Thanks in advance.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Tony Kenward February 24, 2016 at 9:06pm

    Mire aqui:    http://www.hobbyking.com/hobbyking/store/__68694__HK_Pilot_Power_VI...

    • cleninton > Tony Kenward February 25, 2016 at 9:01am

      very interesting thanks for help immediately ask this product

  • Brandon MacDougall February 24, 2016 at 8:57pm

    Some guys use the clone modules that is rated 6s They will work with 22.2 volts as needed.

  • Garrett February 24, 2016 at 8:55pm
    Well, I'm using a Pixhawk, and I'm honestly not sure what the rating of the power module is, but regardless I'm using a 6s battery with no problems. But perhaps I have the high voltage version... If so I apparently got lucky haha.
    • cleninton > Garrett February 25, 2016 at 8:49am

      connect the battery proves the 6s hope it works and if not I will comment that these very lucky ajajaajaj so your power module is special jaajajaja

This reply was deleted.