jdrones ioboard CTS / GND connected

Hi guys,

maybe one of you can help me get the IOBoard running before i try and fry.

Because the support of jdrones seems to be ignoring my ticket weeks ago, and also my other ticket with a reminder (well for me a reason not to buy there again)

after soldering the headers i have get a connection between the CTS and GND pin for some reason. Theres definitly no short due to soldering so i wonder if that is correct or is that a mistake?

thanks

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • clear to send is an active low handshaking line. check the schematic, it's probably there.
  • strange, it must have been something with the nature of my question that nobody is able to answer it.... sigh.

This reply was deleted.