MiniOSD mixed up Character

Posted by Armando on February 13, 2016 at 1:29am

As anybody come across this problem...After updating to Mini OSD Extra 800 and upgrading the characters set the information on the screen doesn't much look like the basic set-up... The horizon doesn't show like a line but mix up of various characters that change with the copter's angle

Also what should be the correct OSD firmware version for AC v3.2.1?....3691275535?profile=original

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Mike Boland February 13, 2016 at 11:39am

    Sometimes the character data is corrupted when loading, especially if the voltage is not high enough.

    I usually plug my FTDI into a powered hub rather than the computer to be sure it gets good current.

    A reload usually fixes it for me.

    Unless the character set you chose is incompatible.

    • Armando > Mike Boland February 14, 2016 at 11:01am

      Thanks Mike...I re uploaded the character set, that came with the installation,  a few time but never through a hub...I managed to solve the problem by going back to the old Arducam 2.20 software and all works great...It gives me all the telemetry I need...

This reply was deleted.