Problem with motor

Posted by Sugeng Priyono on December 13, 2011 at 4:15am

Hi.... I'm  a beginner of using the arducopter using APM 2560, all the instruction I've done,such uploding the APM 2560, calibrating ESC, RC, and the motors have started beeps as usual, but the command from RC doesn't mean for the motors such throttle, pitching, yaw, and roll control......is there any solution????

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Developer
    Jason Short December 13, 2011 at 11:40am

    can you run the radio calibration again? Sounds like you have set wrong.

    Many radios have the throttle output high PWM with a low throttle. You may need to reverse your radio's CH3 output to get low PWM from CH3 when the throttle is low.

    Check all the radio channels and reread the wiki.

    Jason

  • Paul December 13, 2011 at 4:57am
    Are the motors beeping every second non stop when powered with batt?
  • Dave Malcolm December 13, 2011 at 4:45am

    Is the green LED on the board still flashing ? or is it on all the time ?. make sure you are arming the system with rudder

    command to make the green LED on all the time -not flashing.

This reply was deleted.