Problems with APM board (flight mode)

Posted by Haikal Abdul Razak on January 12, 2012 at 2:29am

Hi

I had a few test flight and it works as per normal.

Only recently I have encountered the problem of getting my rotors armed. Usually when power were fed, the LED will blink, waiting for arming. But now, the LED would not even light up.

I even have problem connecting to the ArdupilotMega Planner when my CLI button in flight mode (away from RC pins)

I cannot figure out the problem. I'm in need of help as I'm racing against time which my competition is nearby.

Haikal

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • marc.kulhavy January 12, 2012 at 2:49am

    I had a similar issue some days ago during PID-setup flights. The LED's on the IMU did not lit up, arming the motors sometimes worked, sometimes not.

    I solved it by uploading the firmware again and doing a fresh setup of my radio control.

    Regards

    Marc

This reply was deleted.