Some assistance

Posted by Paul N Braida M.E on March 7, 2015 at 10:19am

Hello:

I just received my new quad.It's a Quanam NOVA and it uses what I'm guessing an APM 2.6 control.I bought the Plug & Fly version so I could use my own TX and RX.

I got the RX installed ok and all tuned in using Mission Planner.After turning the "monitor GPS" parameter off,I was able to arm the control.Problem is that the motors do not spool up.

To calibrate the ESC's,I plugged each one directly into CH3 on the receriver individually and the cal seemed to work,I could spool up and control each motor.Just when connected back to the APM will it not spool up.

Any ideas on this little issue? All are appreciated.

Thanks

Paul B

You need to be a member of diydrones to add comments!

Join diydrones

Replies are closed for this discussion.

Replies

  • The Sun March 7, 2015 at 12:11pm
    Are you arming it?
    • Paul N Braida M.E > The Sun March 7, 2015 at 12:18pm

      yes when connected to my computer it shows armed and also the "armed" led comes on on the rear of the quad.

This reply was deleted.