Total Noob issues with first setup steps!

Hello everyone!

I've been a long time lurker and finally have a ardupilot 2.6.  I have succesfully connected it to Mission planner (v1.2.62).  When I attempt to calibrate the compass I get an error that says "log does not contain enough data"  Can someone tell me what I'm doing wrong?  I did watch the youtube clip and have tried to do as much reading as humanly possible.

Thanks,

Loren

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • Developer

    We've put some work into the wiki.  You've probably already read it but here it is just in case.  There's an advanced compass set-up page as well here.

    In any case, the issue is that when doing the dance (shown on that advanced compass set-up page) you've likely missed some orientations.  Either that or the mission planner isn't receiving data from your compass for some reason.

  • I saw in another forum that you need to hover for awhile and then try again. This should give the log sufficient data.

    Fred
This reply was deleted.