Turnigy Plush at 490hz

Posted by Mark Slater on March 22, 2012 at 11:58am

With 2.5 I noticed the RC_Speed parameter was set to 490, is this the ESC update rate via PWM

If this is the case then my Turnigy Plush seem fine, my question is does the low pass filter in the ESC make much difference. That is - although I think I'm sending 490hz is this being reduced by the ESC itself, is it worth modding the firmware to remove the LPF ?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Chris Kreuzer March 22, 2012 at 12:55pm

    That's the question...

    Is it possible to re-programm the Turnigy Plush 3.1 (new one)?!?

  • Ellison Chan March 22, 2012 at 12:35pm

    Yes PWM updates are now being sent at 490hz.  You can re-program the ESC to match that rate, if your ESC can handle it.  Of course that would help.

This reply was deleted.