Discussion group for ArduCopter users
Drone flying to non visible point
Hi there,I encountered a problem, while flying in auto mode, with approching to point that was not set by trajectory and is not visible after downloading mission from flight controller by Mission Planner. Does anybody encountered similar problem. The situation is that in the middle flight I stopped the UAV and uploaded new mission and after changing to auto mode it starts to fly in some direction. It goes straight to some point, so I assume it's not mechanical problem. I attached the link to…
Read more…
Comments
@Andrew re issues with position hold on AC3.0.1, could you come post the logs on the AC3.0.1 release thread?
Just swap over the cables from roll and yaw.
What mode is your Tx in?
Have you got your Tx set to Heli by mistake, instead of Acro?
In your radio calibration window on mission planner, when you move throttle is only the throttle moving. This window with the moving bars should aid you in sorting out which channels are doing what.
When you move the rudder to the right is the rudder bar going to max?
@Rob, any pics would be useful.
Thanks.
@Bobarry
The holes are so you can stick a rod through the hub and really crank it down tight. I use a really small hex key and it works great. I had props flying off until I figured that one out :)
I suggest posting to a forum, you will receive more help.
The hubs have to be on tight. I check and double check but they work. I have never had one come off.
Also I agree with Jeff. Quads have the potential for serious injury. I took baby steps when I started learning and I'm still learning.
Check your setup again. You'll get in the air, safely.
Randy
Randy
Forum search, http://www.diydrones.com/forum# looking for "hexacopter", no results. Something is rotten in Denmark.
search is not working for me either. A simple search on the word "firmware" yields 'no results'.
Search is working for me
-
22
-
23
-
24
-
25
-
26
of 46 Next