Comments

• DG October 31, 2015 at 9:25am

  Does the FC Failsafe when set up override the motor  cut-off of a HobbyWing Quattro for lost tx signal? According to HW Quattro  manual, it will shut off the motors after 3 seconds IIRC after sensing no throttle. 
• 

  Cala October 30, 2015 at 7:14pm

  Ahh!! It's that perhaps, When you create a blog you can manage answers?, no problem if He prefer like that, I thougth that it was some kind of issue or change with the forum; Thank's Thomas
• 

  Richard Kennedy October 30, 2015 at 7:13pm

  Cala

  But wow!!! 1.5 hour flight!!!! Nice!!!! Way to go Forrest!!

  btw I got the same message when I tried to post  there so it's not just you :] 
• 

  Richard Kennedy October 30, 2015 at 7:11pm

  Cala

  Yea I've never seen that either. perhaps there was somebody being very rude or otherwise posting inappropriate / unrelated comments. 
• Admin

  Thomas J Coyle III October 30, 2015 at 6:42pm

  @Cala,

  I have sent the blog post OP a pm asking him to either remove the OP post review requirement or lock the discussion thread to further posts if that is his intent.

  Regards,

  TCIII Admin
• 

  Cala October 30, 2015 at 6:31pm

  I'm not shure where is the best place to comment about the forum.
• 

  Cala October 30, 2015 at 6:29pm

  Here: http://diydrones.com/profiles/blog/show?id=705844%3ABlogPost%3A1759...

  Thank's for your answer.
• Admin

  Thomas J Coyle III October 30, 2015 at 6:18pm

  @Cala,

  Please provide a link to the post you are referring to.

  Regards,

  TCIII Admin
• 

  Cala October 30, 2015 at 5:47pm

  Sorry guys, you know if something change in forum rules? This phrase appears for the first time for me when I try to write in a post only a common comment, nothing incorrect, "Your comment must be approved before everyone can see it".
• 

  Larry A Amati October 18, 2015 at 5:26am

  I have been a member of this forum for about a year and a half.I like a lot of You have posted problems about our drones.What I have discovered is that many of our issues are our own creation.I have learned to pay close attention to details like balancing motors,props etc.Triple checking motor direction and correct prop (ccw,cw).Also really understanding things like esc calibration,radio calibration.The best advise I would give is to understand the wiki and before you arm your drone check everything again.We should all thank the developers  for putting up with some of our questions on the support forum.Happy flying!