Posted by Varunlal V on October 20, 2015 at 11:28am
I am newbie to this forum and ardurover, I would like to build Ardurover using arduino mega 2560 board, where can i get that wiki, like the pins to connect the Hbridge, gps etc/
You need to be a member of diydrones to add comments!
Interesting project, no feasible, LOT more expensive.
If you are able to duplicate the hardware setup, including lots of additional parts needed, you will have to use an OLD version of Android to compile/load it. Hate to say NO because it usually makes me try harder and waste a lot of time. The old APM 2.5 boards still do the job very well.
Tinker with it, adding things like a water balloon dropper, etc.
Good luck, have fun, hope you can keep your 3 pound brick in the air better than me. :) The props look cool as the brick cokes down
Replies
@Varunlal,
Try here at the bottom of the webpage.
Regards,
TCIII AVD
Interesting project, no feasible, LOT more expensive.
If you are able to duplicate the hardware setup, including lots of additional parts needed, you will have to use an OLD version of Android to compile/load it. Hate to say NO because it usually makes me try harder and waste a lot of time. The old APM 2.5 boards still do the job very well.
Tinker with it, adding things like a water balloon dropper, etc.
Good luck, have fun, hope you can keep your 3 pound brick in the air better than me. :) The props look cool as the brick cokes down