How to calibrate APM 2.6 when the rover is too large rotate

Posted by Al Jones on August 16, 2015 at 6:22am

I am trying to use an APM 2.6 on a Powerwheels jeep with a linear actuator to control the steering.  I am trying to go through the calibration wizard in Mission Planner with the APM disconnected from the Powerwheels jeep.  Not doubt you can understand rotating through 6 degrees of motion is a bit tough if I had to have the jeep, APM and radio receiver all connected at the same time.  

My attempted alternative was to rotate the APM by itself and then connect the actuator and receiver after the rotating step.  Unfortunately the APM disconnects from Mission Planner when I start connecting the radio and receiver.

Any thoughts?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Dan J Pollock September 2, 2016 at 1:25am

    Thanks for that. I've been going crazy trying to figure out how to calibrate my large rover. No way to do it with live. Thanks Chris.

  • This reply was deleted.
    • Developer
      Grant Morphett August 19, 2015 at 4:08pm

      Hi Ben.  You will get a better calibration if you rotate the APM within a powered vehicle however rotating it outside of the vehicle is much better then not doing it at all.

      Thanks, Grant.

  • Developer
    Grant Morphett August 16, 2015 at 6:30pm

    Hi.  Setting COMPASS_LEARN will calibrate the compass but you still need to calibrate the Accels.  What your doing is the correct way for vehicles you can't physically move i.e. power the APM, do the rotation dance and then install the APM into the vehicle.  However, once installed in the vehicle you should also do the "Calibrate Level" process as well.  This is a 1 axis calibration and doesn't require the vehicle to move - only to be level.

    If you try that and still have problems then please post some logs and we will have a look.

    Thanks, Grant.

    • Al Jones > Grant Morphett August 17, 2015 at 10:16am

      Thanks for the guidance.  Now I need to find time to try it.  

    • RoboBill > Grant Morphett August 16, 2015 at 9:11pm

      When I fired up my rover, the mission planner showed its direction to off by more than 180 degrees. After some simple driving around, the orientation started to resemble the rover. Way cool.

      Thanks for clarifying these steps

      RoboBill

  • 3D Robotics
    Chris Anderson August 16, 2015 at 6:40am

    I have the same problem (go-kart) and the solution is to set the rover to learn the offsets as you drive around. Set COMPASS_LEARN to 1 and drive in circles for a few minutes. That should do it.

    3702071845?profile=original

    • Al Jones > Chris Anderson August 16, 2015 at 2:39pm

      Much appreciated.  Will give that a go.

This reply was deleted.