To Start Rover

Posted by yuvraj on January 23, 2015 at 4:14pm

How to start make an autonomous rover so what i need about the components please explain me sir so that i can start my work. so please provide me a which type of transmitter an receiver or any other interface with the rover and required for the job please send me the detail. Can anyone tell me what electronic boards (motor, controller, APM2.6... e.t.c) are required to make a waypoint following robot using the APM 2.6.

Thanks

Yuvraj

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Admin
    Thomas J Coyle III January 23, 2015 at 7:06pm

    @yuvraj,

    Take a look at these rover build logs:

    Link 1 

    Link 2 

    Link 3 

    Link 4

    These rover projects should give you a general idea about what is necessary in the way of components to start building your rover.

    Regards,

    TCIII AVD

    • yuvraj > Thomas J Coyle III January 24, 2015 at 7:49am

      Thanks Thomas for the kind of support ! :) let me go through it :)

      if any doubt let me know Thomas , thanks once again.

      Yuvraj

    • Admin
      Thomas J Coyle III > yuvraj January 24, 2015 at 7:56am

      @yuvraji,

      If you have additional questions after reviewing the build logs, please do not hesitate to ask.

      Regards,

      TCIII AVD

    • yuvraj > Thomas J Coyle III January 25, 2015 at 6:58pm

      @Thomas

      I have gone through everything my thinking is that I will buy any rc car and modify it as autonomous rover but I don't understand that how do I connect the Brushed-Motors and Brushed-Esc & If I use rear two motors will produce the torque , I'am gonna modify this car itself only http://www.rcbazaar.com/product.aspx?productid=3525  I got lot of confusion in my mind Thomas ! help me out !

       

    • Admin
      Thomas J Coyle III > yuvraj January 25, 2015 at 7:18pm

      @yuvraj,

      Start here Link 

      Regards,

      TCIII AVD

    • yuvraj > Thomas J Coyle III January 26, 2015 at 3:50am

      Thank You Thomas I got the first step luv u :) If further any help let u know :)

      Yuvaraj

    • mark sahf > Thomas J Coyle III January 23, 2015 at 9:01pm

      I purchased a 21st century toy co. 1/6 tank which had all kinds of space inside. Had to put new tracks on to as its gear ratio made it go to fast and lose a track, only paid $30 for the tank picked up new stronger motors and the metal gearing to replace the plastic gears cheep on ebay also. Son and I built a board, added a receiver and radio from years ago 72MHZ and then some creative ideas with the 3d printer. Still had about $150 into it but it was fun building. Nice job on your build, now see what it can do! Have fun,

      Mark

    • yuvraj > mark sahf January 24, 2015 at 7:49am

      hi mark let me take a single step once completed let u know bro :)

      Yuvraj

This reply was deleted.