Replies

  • Michael Burmeister February 17, 2015 at 3:38am

    I think this is it: http://www.digikey.com/product-detail/en/ZHR-4/455-1202-ND/608643

    Looks like the pins go straight in so you got a 50/50 chance at it.

     

    • Richard Jacobs > Michael Burmeister February 17, 2015 at 1:51pm

      I ordered several of those connectors from digikey.

      I could not find that little connector!

      Thanks.

    • Richard Jacobs > Michael Burmeister February 17, 2015 at 4:37am

      Thanks for the link.

      50% chance at wiring a $230 device incorrectly, seems risky. There must be a way to determine which way they go?

    • Richard Jacobs February 17, 2015 at 1:51pm

      This is extremely helpful. Thank you

    • Erik Graham February 17, 2015 at 7:40am

      Tomas,  your video is private.  I wasn't able to load it.  Meantime, I posted some images for Richard (above).

    • Erik Graham > Richard Jacobs February 17, 2015 at 5:43am
      I switched to the DYS 3 axis gimbal but I still have my Tarot 2D. I could try to take some pictures or video along the length of that cable so you can figure out how they pin out. It will be awhile before I can get to it.
    • Eddie Tun > Erik Graham February 18, 2015 at 7:07pm

      Erik,

      How yours DYS3 axis working. I fix my Tarot 2D after I change motor, suspension plate, and still have problem at tilt. It jittery at one point and and cannot adjust it. I will like to change to DYS 3axis. I know you have put up at last thread but I did not save it. If everything working fine with yours can you please email to me how it wiring and set up.

      Thanks

    • Erik Graham > Erik Graham February 17, 2015 at 7:37am

      Here is how my Tarot 2D is wired.  The pencil in the two images below is touching the same wire.  That should be enough to orient you.

      3702778633?profile=original

      3702778145?profile=original

  • Richard Jacobs February 16, 2015 at 8:08pm

    Not afraid to solder, but I am wondering how those wires pin out? They're not marked or colored.

    Also, where is there a good source online for these types of connectors?

    Thanks!

  • Jimmy Oliver February 16, 2015 at 8:07pm
    look for 3 pin jst connectors
This reply was deleted.