APm MinimOSD

Posted by Tony Anthony on November 3, 2014 at 6:36am

Bench testing my PixHawk and trying to get all systems working ...going fine untill I connected up the APM MinimOSD.  No Video or OSD.  I know the video setup is working because when I pull hte MinimOSD out of the connection I have very good video. 

 

This is a 5.8 set up.    The MinimOSD has a red light on both sides of the card and the small (green/white) light is flicking.  I have re-ckecked conections several times.  Looking for some more thought before I return the MinimOSD for a new one. 

tanthony

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • This reply was deleted.
    • Tony Anthony November 3, 2014 at 11:41am

      Darren , thanks for your reply.  I and using Telem 2  I have not tried to switch to port 1.

       

      I have not run the OSD through the firmware upgrade .  Plan on doing that tonight.  That may be the missing link.

      Been doing a lot of reading about installing the OSD Minmi. 

  • This reply was deleted.
    • Tony Anthony November 3, 2014 at 7:22am

      Bill thanks for your reply.  I have the Video transmitter on a  sepreate battery 3s 11.1.  Being on the test stand the servos are not active and the battery prowing the PixHawlk are freasly charged. 

This reply was deleted.