Access Solo/Pixhawk 2 aux 1/relay pin

Posted by Are Jo Næss on April 25, 2016 at 3:08pm

Hi guys!

Have anyone tried to access aux 1 (pin 50), (or other aux ports and ground pin) in 3DR Solo (Pixhawk 2).  I need it to trigger a Sony camera with cam_trig_type: relay, which is quite trivial on pixhawk 1.  3DR support wouldn't help me out with this..

Regards

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Didier Wasselin August 24, 2016 at 10:25am

    Anyone have some picture with the pin of mainboard et the position of RC9/ RC10 ?

    It's for connnecting a cable Gentled for shutter RX100.

    Thanks

  • Ahmed Agbabiaka April 26, 2016 at 9:13am

    the aux pins are disconnected from the accessory bay. if you want aux pins, you'll need to either tap into them from the main board or connect the aux pins to the respective points the accessory bay connector.

This reply was deleted.