3D printed Talon gliding pad cover

Posted by Hugues on March 15, 2015 at 11:52am

Hi,

For those who'd be interested, here a 3D printed gliding cover if you land without the wheel like I do. It is meant to protect the bottom front landing/gliding pad (where the front wheel is positionned)

attached the STL file.

Cheers,

Hugues

capottalon.stl

You need to be a member of diydrones to add comments!

Join diydrones

talon, xuav, landing, pad

Email me when people reply –

Replies

Scott Pritchett March 15, 2015 at 2:13pm

Nice! I've normally just put a piece of 1/16" ABS sheet over the bump for the same purpose.
- MR60
  
  Hugues > Scott Pritchett March 16, 2015 at 6:54am
  
  Nice!
  
  Is the nose piece also in ABS ? Do you have the STL files for that ?
  
  What glue do you use to glue ABS on EPO foam ?
- Will Snodgrass > Hugues September 7, 2015 at 11:16pm
  
  foam safe ca is what I use for gluing 3d printed stuff to my plane
MR60

Hugues March 15, 2015 at 11:55am

Note : The front camera hole is not printed so you can decide to have it or not (just drill the hole). Also, the front line on the fuse (toward the nose) prints as a straight line; so you can sand it off to match the shape of your Talon's nose.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

X-UAV Talon

Replies