Post your x8 setup and endurance times the setup has done.
I will start.
I have the APM 2.5 with ublox lea6 GPS
Airspeed sensor
MB1260 XL Sonar (Not sure if it is working or providing anything to the setup)
5.8GHZ 500mw FPV system with Fatshark Dominator goggles and clover leaf antennas
Micro Compact Super Vision CCD Camera
2* Turnigy 4500 3S batteries (I want 2 * 4S 5000mah)
Attopilot 45AMP (I Think this is not enough need mabey a 108AMP)
Folding Propeller Assembly 13.5x7 (Alloy/Hub Spinner)
Corona DS-319MG Digital Metal Gear Servo 4kg / 34g / 0.06s
Turnigy Aerodrive SK3 - 5045-500kv Brushless Outrunner Motor
TURNIGY TRUST 70A SBEC Brushless Speed Controller
I do not have an endurance time yet, for I am
Replies
Guys I need some help with my power set-up. From what I've seen most are using a seperate UBEC to power servos on their X-8. I've read the wiki and instructions but everyone seems to have a different opinion on how to configure usig the new APM 2.5 power module.
Here is my set-up-
APM 2.5+ w/ power module
70A ESC/ wBEC
Caslte 5V BEC (NOT USED YET) Cant figure out how to use it with APM power module
Aurora 9 radio
2 x 3300 4S batteries
Other misc systems, IE camera Tx,etc. Own power source.
Getting ready to maiden this ship and dont want my servos to brownout and crash. What to do?....
Any news about the endurance time?