Wing reinforcement & servos

Posted by Martin Poller on December 21, 2012 at 4:03am

Just doing some research before I commence my build and was wondering what the general opinion of the forum is on a some points.

1. I've read that the standard CF wing connection tubes can break and the wing can flex if it is heavily loaded or flown in in strong winds so should I add additional stiffening spars and upgrade the CF tubes that are provided as standard.

2. I'd like to cover the wing as this stiffens it too, what covering material would you recommend, Wessie refers to a plastic film with a heat activated adhesive, is this just solarfilm, and should I put reinforced packing tape along the leading edges first, or is this just adding unnecessary weight?

3. Are Hitec HS 82 MG up to the job or should I go for standard size servos, I found these Hitec slimwing

are they any good?

I'm grateful for any advice, I am keen to get started given the ideal buildiing weather we are currently having.

Thanks

Martin

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • This reply was deleted.
    • Martin Poller May 26, 2015 at 1:41pm

      Thanks Tom,

      It's still in it's box awaiting construction, but will have to wait till I get to grips with my other Skywalkers.

      I've mastered covering with plastic film, did you cover your X8.

      I take your point about the HS-225MG and they're less expensive than the HS-82MGs.

      I wasn't aware that the current kit had been upgraded, could you be able to give me details of the carbon fibre strips, where they are located and the dimentions of the strips, or maybe post some pictures.

This reply was deleted.