"well 46 seconds for low battery alarm which is set to 3.4, i know my charger is off by .42Mah when charging.so most of these numbers will have a error or like .9-.4. so to get the estimated 10% for cutoff so should be at 250 mah of use, which seems…"
"ok so i bought a watt meter to see what is going on, pluged it into my quad, so my full setup with 4 motors and selected props secured with a vice
x4 motor ntm2830 800kv 300watt with a 2200 30-40c lipo battery
test 1 8x4.5 1.16 minutes…"
"one of the best write-ups i have seen. did you flash your esc's i am using a similar setup. plan on putting my go pro on but currently my
sk450 quad weighs out at about 938grams without battery
ntm800kv 300 watt motors downgraded from the 1200kv…"
"YES but what are your motors pulling. the charger i bought is good for up to 6 cell lipoly, li-ion, and NIMh, NICd...and has good support from the internet and i have more or less checked the voltages with multi meter to check accuracy of the…"
to start out i am fairly new. i have had my quadcopter for about 6 months now with mixed results. ultimately it is up and running. it is tuned and flying stable however i loose altitude easily. getting to the pointWhat i am usingturnigy 9x…