Gender
Male
About
Location
SA
Please tell us a bit about your UAV interest
Development and research
Hometown:
Adelaide
Activity Feed
"Hi All,
I have +20 years of photogrammetry and drone mapping experience and respectfully I don't believe that this technology would help in cost and time saving neither in achieving reliable results, due to the following reasons:
Targets have to be…"
I have +20 years of photogrammetry and drone mapping experience and respectfully I don't believe that this technology would help in cost and time saving neither in achieving reliable results, due to the following reasons:
Targets have to be…"
"Hi Andrew,
Thanks for your great work! Just letting you know that LAND command doesn't work in non airspeed altitude hold algorithm!
Cheers,
Ami"
Thanks for your great work! Just letting you know that LAND command doesn't work in non airspeed altitude hold algorithm!
Cheers,
Ami"
"Hi Andrew,
Good on you! I'm trying to use do_set_parameter , do_repeat_servo and do_mount_control commands in MP1.2.12 as well as the older versions which seems non of them are working! Can you please advise...
Cheers, Aami "
Good on you! I'm trying to use do_set_parameter , do_repeat_servo and do_mount_control commands in MP1.2.12 as well as the older versions which seems non of them are working! Can you please advise...
Cheers, Aami "
"Look forward to having the new release Andrew...,
Thnaks!
Aami"
Thnaks!
Aami"
"Hi Andrew,
I've attached the log file for the Mount servo chattering issue for Rc5,6 and 7 channels (only one of them is chattering coincidentally), it happens even the GPS has good 3D lock and airspeed is enabled!
Cheers,
Aami"
I've attached the log file for the Mount servo chattering issue for Rc5,6 and 7 channels (only one of them is chattering coincidentally), it happens even the GPS has good 3D lock and airspeed is enabled!
Cheers,
Aami"
"Hi Andrew,
I've just updated to 6.3 and noticed that the outputs from Rc5, Rc6 and Rc7 for mount control causes servo chattering every 14 seconds! It seems there is a regular noise coming out from these channels which causes servos jumping every…"
I've just updated to 6.3 and noticed that the outputs from Rc5, Rc6 and Rc7 for mount control causes servo chattering every 14 seconds! It seems there is a regular noise coming out from these channels which causes servos jumping every…"
