Hello all,
Does any one know why do ublox lea6h gps evaluation boards ($100) cost less than the module ($120) itself?
Here's the link for eval board that i bought at $99.99:
http://www.csgshop.com/product.php?id_product=35
Here's the gps module chipset
Read more…Hello all,
I'm trying to get the waypoint navigation in HIL simulation using XPlane, but not successful yet.....with the default HIL firmware and the config file "AC211r6_Xplane.param" available in the starter_pack, i observe the following:
- The quad
Read more…Got a successful comm between Arduino Mega 2560 and Hokuyo URG-04LX-UG01 LiDAR using a Vinculum VDIP1 USB host controller.........
The code sends VV command to Hokuyo LiDAR, and receives response @ 9600 baud. Other commands can be implemented in simil
Read more…I'm writing the waypoint file to apm via USB at my lab, and reading it fine in flight planner (with battery disconnected).....then i go to some other location, connect battery n fly.....but copter doesn't follow waypoints....instead, it hovers around
Read more…I'm trying to connect to Arducopter via XBee Pro 900 to APM Mission Planner with port speed set @ 57.6 kbps....it shows connected, i see the icon displays "Connected" for some time, but APM Mission Planner window stops responding....
After some time,
Read more…My Arducopter takes off perfect....no roll, no yaw....after rising above around 1 meter off the ground, it develops a small drift over 1 side, and starts moving with small horizontal velocity....
I see the platform as well as in HK GCS, n gyro readin
Read more…