Carlito Oliveira's Discussions

Carlito Oliveira's Discussions (4)

Sort by

PPM Input in UAV Dev Board (Coded And working!!!! with Failsafe!!!!)

********************************************************************

Update!!!!

**************************************************************

Now I've Coded to read the PPM and tested, it's working fine! That means you only need one channel to read all

Started by Carlito Oliveira

Sparkfun Magnetometer Mount on UAV Dev Board V2 (EMI problems???)

Hello,

I've just finished my 3V3 regulated board for sparkfun magnetometer to connect it to the uav dev board 2.

I bought it a long time ago, back then there was no jordi's board, so I'm improvising here. I'd like to know if my 3V3 regulator is capable

Started by Carlito Oliveira

Experience w/ BootLoader for dsPIC30F4011 (UAV Dev Board)?????

Hello Everyone,

I'm looking forward to install a bootloader in my UAV Dev Board and I've been reading a lot about it in microchip's website, but I wanted to know if anyone have already had success installing and operating it in UAV Dev Board?

That woul

Started by Carlito Oliveira

DIY UDB2 Expansion Board - Pitot Tube, AOA, Volt and Current added

Hi,

I've made a expansion board for the UAV Dev Board 2 that reads 4 more sensors(Pitot Tube, AOA, Volt and Current).

It's not 100% completed yet cause the I2C functions are missing, but I decided that this was time to doccument it before It gets to lo

Started by Carlito Oliveira

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

PPM Input in UAV Dev Board (Coded And working!!!! with Failsafe!!!!)

Sparkfun Magnetometer Mount on UAV Dev Board V2 (EMI problems???)

Experience w/ BootLoader for dsPIC30F4011 (UAV Dev Board)?????

DIY UDB2 Expansion Board - Pitot Tube, AOA, Volt and Current added

Note: this page contains paid content.