I would expect this parameter to have the exact same name, because these are Pixhawk parameters. So whatever software you use to configure your quad the parameter names should be the same.
Like I said in a previous post, that one I have already fixed. In my case I only had to look for the GPS_TYPE and GPS_TYPE2 parameters and set GPS_TYPE2 to "Auto".
After that my GPS device was detected again.
"I'm not sure if I will yet! I'll look first for any more other issues and then decide if it is worth the trouble to revert and possible to tune it all over again.
You can always compile the previous release and install it through MP (there's an…"
"Well in the meantime, browsing through the Full parameter tree I've found these two parameters:GPS_TYPE and GPS_TYPE2 for a 2sd GPS.Now, I don't remember to ever had to configure these, but in this case:GPS_TYPE = 1 (which is "Auto"…"
I'm new to the forum and to the RC world also, but since I've recently struggled with my DJI ESCs (at least that was what I thought...) that came with the DJI F450 flamewheel set, I decided to post where went wrong. Basically my quad kept…"