Gender
Male
About
Location
Des Moines, IA
About Me:
I fly quadrocopters and drones.
Please tell us a bit about your UAV interest
working on a adruplane currently
Hometown:
Des Moines
Activity Feed
So I have been messing around with the Do_set_servo command in mission planner but have ended up destroying two servos with it. the PWM was within range as I had them in manual mode beforehand. once I activate auto mode it seems to push them as hard…
So I have been messing around with the Do_set_servo command in mission planner but have ended up destroying two servos with it. the PWM was within range as I had them in manual mode beforehand. once I activate auto mode it seems to push them as hard…
"Any suggestions as to how to use this command and avoid overdriving future servos? I must be doing something wrong with the commands as I have seen others do the same thing successfully."
"Thanks for the quick response, The servos are connected through the APM. I went into the calibrate radio and the low and high are 1000 and 2000. also the teeth did not strip from the set servo incident, that was my fault as I was trying to get the…"
