About

Gender

Male


Location

London


Please tell us a bit about your UAV interest

Just building my first quad copter - my first electronics project too.


Hometown:

London


Activity Feed

Chris Evans posted a discussion
Hi all,I've dug out my quad and updated the firmware, calibrated and was about to go for a flight when I realised the flight planner is reporting the wrong roll values - they are revered e.g. if the quad is facing away from you, and you roll the…
Jan 25, 2014
Chris Evans replied to Chris Evans's discussion Current / voltage sensor giving weird readings
"Thanks for all the replies, I've tried all of the suggestions and still get the same results.  I've got two batteries, tried both with the same results.  I've measured the voltage out of a newly charged battery and it 12.6 as expected.  Does anyone…"
May 12, 2012
Chris Evans replied to Chris Evans's discussion Current / voltage sensor giving weird readings
"Hi Andreas,
Thanks for the reply - yes I did, I entered 2200 in that box.  The strange thing is, it's not a constant reading i.e. it's not like it's just a bit off, I can see from other posts that some settings need tinkering when you get a slightly…"
May 11, 2012
Chris Evans posted a discussion
Hi Guys,Just popped on a 90a AttoPilot current sensor onto my APM2 based quad rotor which has a 3 cell 2200ma lipo.  As far as I can see everything is hooked up correctly however as soon as I connect the lipos and connect via Mission Planner (over…
May 11, 2012